Gate Hinge Pin for 34mm Galvanised Pipe img2 It tapers from 43mm in

It tapers from 43mm in diameter to 29mm in diameter

This fitting may sometimes be used to fix flat sheets to tubes

The 156 Slope Cross (Middle Rail) is adjustable for slopes from 0 degree to 11 degree

Plantation-grown

Gate Hinge Pin for 34mm Galvanised Pipe img2 It tapers from 43mm inWhere would you normally use this galvanised pipe fitting? The 140 Gate Hinge Pin is often used with type 138 to form gate hinges. This fitting cannot be used where through tube (vertical in photo) has to be joined within the fitting. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 34mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot