Tee Left Corner Decline (30-45 degrees) for 48mm Galv Pipe Square Stainless Where would you normally use

Where would you normally use a Gumnut fretwork panel

This style is also available to suit 90mm and 155mm square posts

No welding is required

Plantation-grown Radiata Pine that has been finger-jointed

Tee Left Corner Decline (30-45 degrees) for 48mm Galv Pipe Square Stainless Where would you normally useWhere would you normally use this galvanised pipe fitting? The 283 is a 90 degree corner joint, often used where top rail meets corner upright on angled sites. Often paired with type 116. What size pipe does it fit to ? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 48mm. What is it made out of ? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed the requirements